External Control With Robotino ® View - Festo Robotino 4.0 Notice D'utilisation

®
Robotino 4.0 Mobile Robot System
10 External control with Robotino
Proceed as follows to control your Robotino
programming environment.
1. Installation
Run the current setup file for Robotino
the Festo Didactic website to download the current setup file. Enter "Festo Didactic Robotino View" in
the search bar.
2. Connecting to the network
– WLAN
Connect your desktop computer or laptop to your Robotino
– Ethernet cable
Connect the Robotino
Go to the Windows Control Panel and open the "Network and Sharing Center."
Click "Change adapter settings." Right-click the "Local Area Connection" and select "Properties."
Select "Internet Protocol Version 4 (TCP/IPv4)" and click "Properties."
Enter the IP address 192.168.0.10. Choose "OK" to confirm.
3. Starting Robotino
Start Robotino
4. Connecting Robotino
Enter the currently valid IP address in the input field for the IP address of Robotino
The default IP address of Robotino
Press the Enter key or click on the buttons with the antenna symbol directly to the left of the input field
to establish the connection.
Once the connection has been established successfully, the button and the input field are disabled and
the connection quality is displayed by the antenna symbol next to the input field of the IP address.
Three bars indicate the highest connection quality.
50
®
®
®
4.0 to your PC using the Ethernet cable.
® View
® View.
®
View
®
is 192.168.0.1
® View
4.0 externally using the Robotino® View graphical
View. You require administrator permissions to install it. Visit
®
4.0 via the WLAN network.
® 4.0.
© Festo Didactic 8101524