Miche SWR CARBON Manuel D'utilisation Et D'entretien page 8

may need to remove your Miche wheels from your cycle to do so]
• To the users of more than 85kg weight, Fac Michelin suggests
to check the wheels status to the mechanic every two months or
every 1,500km.
SECTION II -
Hubs
SWR hubs are easy to maintain. To do it, proceed as follows:
• Insert two keys (A) in the extremity of the hubs (Pic1).
and turn them in anti-clock sense.
• While you are taking out the mobile side, take out from the
opposite side the complete pin.
Front hub
Front hub does not need any particular maintenance.
• Once you take out the pin from hub's body, you could, if it is
necessary, change the bearings.
To reassembly it:
• Put the pin into the hub's body and lock with power the mobile
side with a torque of 15 Nm. If necessary, adjust the hub by
working on the ring (D):
B
E
D
A
• Unlock the grub screw (E) with a key (B) (Pic1).
• Turn the ring clockwise to drop the sliding, and anti-clockwise
to raise the sliding. Lock the grub screw (E).
Check the sliding of the wheel.
Please check that the hub is correctly tightened and closed,
failure to do so could lead to a serious or fatal accident.
Warning! We trust to use original spare parts supplied
by Fac Michelin.
B
E
A
Rear hub
• Once you take out the pin from hub's body (Pic2), the free
A
C
A
wheel body (C) stays attached with his pawls (Pic.3).
• Clean carefully the pawls then put some low-density grease.
• Re-fit the pin (C) inside hub body with the spacer.
• Take care to position of the pawls positions. Lock with power
the mobile side with a torque of 15 Nm, if necessary adjust the
hub by working on the ring (D):
• Unlock the grub screw (E) with a key (B) (Pic.2).
• Turn the ring in clock sense to drop the sliding, and in anti-clock
sense to rise the sliding. Lock the grub screw (E).
Check the sliding of the wheel.
Please check that the hub is correctly tightened and closed,
failure to do so could lead to a serious or fatal accident.
Warning!
We trust to use original spare parts supplied by Fac
Michelin.
D
SECTION III -
Spokes
The spokes used to assembly the SWR CARBON and SWR FULL
CARBON Wheels have the following measure and features:
SWR CARBON Wheels
Rear Wheel
Right side (cassette sprockets side)
Left side (cassette sprockets opposite side)
Front wheel
Spokes are flat variable diameter: 2,3 – 2 – 2,2 mm
SWR FULL CARBON Wheels
Rear Wheel
Right side (cassette sprockets side)
Left side (cassette sprockets opposite side)
Front wheel
Spokes are flat variable diameter: 2,3 – 2 – 2,2 mm
Inverse nipples of SWR CARBON Wheels measure 12 mm, are inner to
the rim and have square head and are in brass.
Nipples of SWR FULL CARBON Wheels measure 16 mm, have hexa-
gonal head and are in brass.
CHANGE A SPOKE
Warning!
Before changing the spoke, be sure to have correctly clea-
ned the inside area of the rim where the nipple touches.
8
E
295 mm
274 mm
274 mm
295 mm
252 mm
264 mm
ENGLISH