Télécharger Imprimer la page

NSK DynaLED Manuel D'opération page 15

Publicité

Les langues disponibles

Les langues disponibles

CAUTION
• Tighten the head cap after changing the cartridge. If attachment is loose, there are the causes of an injury in
oral cavity or possibility of accidental ingestion.
• Use only NSK purity cartridge. Competitive cartridge is not covered under warranty.
• The screw of head cap is very small. Do not bind tight using a Wrench from the start. After tightening by the
hand, use the Wrench.
• Check that the O-Rings are placed correct position and then install the cartridge.(Fig.10)
7.Spray Port Cleaning
When spray port are clogged, or spray does not exit evenly from three ports, clean the ports as follows:
1) Remove the bur from the chuck. (Refer to "4. Insertion/Removal the Bur" and "6.
Replacing the Cartridge")
14
O-Ring
O-Ring
Spray Port
Cartridge
Fig. 10
Cleaning Wire
Cleaning Wire
Fig. 11

Publicité

loading