bort medical 215 880 Mode D'emploi page 14

Les langues disponibles

approx. 3 cm between the pull loops and the guide loops for the shoulder straps. Pad

the shoulder straps in the armpit region using the enclosed strap pads.

To reduce tension to the armpits and avoid strangulation, you can correct

the course of the strap by changing the position of the dorsal guide loops

(attached to the back plate with Velcro). The level of the costal arch serves as a

reference point.

In order to achieve ideal straightening of the patient, then use the pull loops in

sync to tighten the torso and shoulder straps. Avoid overcorrection.

To reduce tension or remove the brace, tilt the shoulder strap's guide loops downwards

and upwards with your thumbs as for a rucksack [Image 3]. Check the correct fit of the

brace: Are the harnesses too tight or do they cut in?

Dynamic setting of the brace

Step 1 [Image 4] Remove the Velcro protector on the lower inner side of the brace.

Then, remove the back plate from the splint bag with the attached reinforcement

module.

Step 2 [Image 5] Detach the connecting clasps which connect the reinforcement

module to the back plate. For this, press the side lever on the grey clasp downwards,

spread it apart and push the clasp away outwards.

Step 3 [Image 4] Then, push the back element back into the brace and tighten the

Velcro protector.

Step 4 [Image 14] To realise dynamic reclination, the overlay which can be attached

using Velcro in the shoulder height region must be removed.

Information: Store the reinforcement plate and overlay carefully in their packaging.

During later care phases, it may be necessary to again make more stable settings.

Tip: You can find our video, which shows the attachment process, both on our

homepage and via the product-specific QR code.

Material composition

Polyurethane (PU), polyamide (PA), cotton (CO), polyester (PES), elastane (EL), helanca (PA)

The sewn in textile label provides the precise material composition.