Husqvarna P 520DX Manuel D'utilisation page 58

10. Attach the third strap to 1 of the transport eyelets.
11. Attach the fourth strap to the other transport eyelet.
12. Attach the strap to the load area.
13. Tighten the strap forward to attach the product to the
load area.
14. Put the wheel chocks in front of and behind the rear
wheels.
To tow the product
The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
Disengage the transmission before you tow the product.
To disengage the hydrostatic transmission on
Refer to
page 29 .
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage.
To prevent tacky particles during storage, add a
stabilizer. Always use the mixing ratios given by the
manufacturer.
• Add stabilizer to the fuel in the tank or in the
container used for storage, to prevent damage to the
engine.
• Run the engine for a minimum of 10 minutes to let
the stabilizer flow into the fuel injection.
58
WARNING:
with fuel in the tank in an indoor location or
in locations with bad airflow. Risk of fire if
fuel fumes come near open flames and
sparks.
• Turn the main switch to the OFF position. Refer to
To stop the engine on page 28 .
• Clean the product, refer to
page 32 . Repair paint damages to prevent corrosion.
WARNING:
other flammable materials from the
product to decrease the risk of fire. Let
the product become cool before you put
it in storage.
• Examine the product for worn or damaged parts and
tighten loose screws and nuts.
• Remove the battery. Clean it, charge it, and keep it
cool during storage.
• Change the engine oil and discard the waste oil.
• Empty the fuel tank. Start the engine and run it until
there is no remaining fuel in the fuel injection.
Note:
Do not empty the fuel tank and fuel injection
if a stabilizer is added.
• Remove the glow plugs and put about a tablespoon
of engine oil into each cylinder. Manually turn the
engine shaft to apply the oil. Attach the glow plugs.
• Lubricate all grease nipples, joints and axles.
• Keep the product in a clean and dry area and put a
cover on it for more protection. A cover for protection
of your product during storage or transport is
available at your dealer.
Storage of the cabin
WARNING:
The cabin is heavy and can cause serious
injuries. Make sure the cabin is stable during
storage.
• Repair paint damages to prevent corrosion.
• Examine the product for worn or damaged parts and
tighten loose screws and nuts.
• Keep the product in a clean and dry area and cover
it for more protection.
• Keep the product in a locked area away from
children and other not approved persons.
• Put the cabin on the cabin support during storage.
Cabin support dimensions on page 66 .
Refer to
Do not keep the product
To clean the product on
Remove grass and
Move the cabin carefully.
1593 - 005 - 25.10.2021