Husqvarna P 520DX Manuel D'utilisation page 52

Lubrication overview
9
4
6
7
For 1–7, use kalcium grease.
For 8, use lithium complex grease.
1. Steering cylinder - front
2. Rear axle splines
3. Control stay
4. Front axle splines
5. Steering cylinder - rear
6. Pedal shaft. Two positions.
7. Lift arms
8. Bearing housing (high temperature lithium grease)
9. Lift cylinder
10. Articulated steering joint
Lubrication, general information
• Remove the ignition key to prevent accidental
movements during lubrication.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the product
daily.
52
1 3
4
8
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
alcohol. If the friction between the drive belt and the
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION:
petroleum products to clean drive belts.
2
5
10
Do not use gasoline or other
1593 - 005 - 25.10.2021