Husqvarna P 520DX Manuel D'utilisation page 34

To remove the transmission cover
1. Remove the 4 screws.
2. Lift and remove the transmission cover.
To replace the headlights
1. Remove the front cover of the steering column.
To remove and install the front cover of the
Refer to
steering column on page 32 .
2. Remove the 3 screws of the headlights.
3. Remove the headlights.
4. Assemble in opposite sequence.
To replace a low and high beam lamp (P
525DX Cabin)
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
34
3. Push the spring lock and remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 60 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace a parking lamp
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 60 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace a turn signal lamp
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Turn the lamp counterclockwise and remove the
lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 60 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
1593 - 005 - 25.10.2021