Husqvarna P 520DX Manuel D'utilisation page 23

4. To adjust the lumbar support, turn the lever (F) to the
left of the backrest. Turn the lever counterclockwise
for more support.
F
To tilt the seat forward (P 520DX, P
525DX)
• Pull the lock lever up and tilt the seat forward.
To tilt the seat forward (P 525DX
Cabin)
1. Remove the 2 knobs and the 2 washers.
2. Tilt the seat forward.
To adjust the pedals
WARNING:
during operation of the product.
1593 - 005 - 25.10.2021
Do not adjust the pedals
1. Remove the cutting deck. Refer to
cutting deck on page 18 .
2. Remove the service hatch. Refer to
service hatch on page 33 .
3. To adjust the forward pedal do the steps that follow.
a) Loosen the 2 locknuts (A).
C
C
b) Turn the rod (B) clockwise to make it shorter.
c) Put the pedal in transport speed mode.
d) Push the pedal down to a full stop against the
physical stop in the foot plate. Keep the pedal in
this position.
e) Adjust the rod (B) to make it longer, until it stops.
At this point the hydraulic pump has come to a
mechanical internal stop.
f) From this point, turn the rod (B) in the opposite
direction ½ turn to release the contact in the
hydraulic pump.
To remove the
To remove the
B
A
23