Troubleshooting - Husqvarna P 520DX Manuel D'utilisation

To lubricate the articulated steering
joint
1. Lubricate the articulated steering bearing when the
product has all wheels on the ground.
2. Lift the product to release the pressure in the
articulated steering. The illustration shows where to
put the supports.
CAUTION:
support does not cause damage to the

Troubleshooting

If you cannot find a solution to your problems in this
manual, speak to your Husqvarna service agent.
Problem
The starter motor does not turn the
engine over
1593 - 005 - 25.10.2021
Make sure that the
Troubleshooting
Cause
The PTO-button is activated.
The parking brake is not applied. Refer to
brake on page 28 .
The main fuse is blown. Refer to
The ignition lock is defective.
The connection between the cable and the battery is bad.
The battery is too weak. Refer to
The starter motor is defective.
control stay or causes a blockage of the
articulated steering.
3. Lubricate the articulated steering bearing again while
the product is lifted.
4. Lower the product.
To lubricate the drive shaft
1. Remove the service hatch. Refer to
service hatch on page 33 .
2. Lubricate the 4 grease nipples with a grease gun
until grease comes out.
To apply and release the parking
To replace a fuse on page 40 .
To charge the battery on page 41 .
To remove the
53