for any matters that are not referred in the above
23. Note: For specific maintenance and safety information about this product, consult the user's
manual provided with it. If it has been lost or misplaced, contact your local retailer for a replacement.
24. Important: The information contained in this instructions manual describes components available
at the time of publication. We reserve the right to make changes without prior notice and without
obligation to make alterations to components previously manufactured.
The procedures described in this manual are intended to help you get the most from your machine as
well as to protect you and others from harm. These procedures are guidelines for safe operation under
most conditions, and are not intended to replace any safety rules and/or laws that may be in force in
your country / area.
IV. GETTING STARTED
4.1- Unpacking
4.1.1- For PREHLS52 / 042001 ; PREHLS52/5 / 042031 and PREHLS7T / 042011
We recommend that at least 2 persons unpack the log splitter package.
Remove product from its packaging.
Check that product and accessories are not damaged.
4.1.2- For PREHLS7T/V / 042021
We recommend that at least 2 persons unpack the log splitter package.
Content of the packaging (fig.4) :
A. Log Splitter Frame ............................. 1 set
B. Control Lever and Guard Assembly ... 2sets
C. Removable Support Table .................. 1 pc
D. Owner's Manual ................................. 1pc
Take the following steps 1 to 5 (see figs.5) :
- Put the Log Splitter on the ground by tipping every side of the
Fig. 4
carton by 45 degrees (turn the carton to its 4 sides to successively
open the 4 flaps).
- Make sure to put box (B) to support the Log Splitter box (A) at a point a little higher than the middle.
- The other side of box (B) shall be against steady object, such as a wall.
- A wedge (C) shall be arranged under the tipped Log Splitter Package (A) to avoid slipping.
- Then remove the carton off the Log Splitter.
Fig.5a
Fig.5b
Fig.5c
Fig.5d
Fig.5e