Ribimex Ribiland PREHLS52 Manuel D'instructions Et D'utilisation page 28

V. OPERATION
5.1- Intended use
The log splitter is machine intended to split firewood, in which the log is split through the pressure of
a slab against a fixed wedge.
5.2- Application conditions
This log splitter is a home use model.
It is designed for operating under ambient temperatures between +5°C and 40°C and for installation at
altitudes no more than 1000m above M.S.L.
The surrounding humidity should less than 50% at 40°C.
It can be stored or transported under ambient temperatures between -25°C and 55°C.
5.3- Before operating the log splitter
1. Familiarize yourself with the controls and features of the log splitter (refer to the illustrations).
2. The Bleed Screw should be loosened by some rotations until air can go in and out of the oil tank
smoothly. Air flow through the Bleed Screw hole should be detectable during the log splitter is under
operations.
3. Before moving the log splitter, make sure the bleed screw is tightened to avoid oil leaking from this
point.
Failure to loosen the bleed screw will keep the sealed air in the hydraulic system.
The air being compressed and then decompressed, such continuous air compression
and decompression will blow out the seals of the hydraulic system and cause
permanent damage to the log splitter.
4. Plan your work site.
Work safely and save effort by planning your work before hand.
Have your logs positioned where they can be easily reached.
Have a site located to stack the split wood or load it onto a nearby truck or other carrier.
5. Prepare the logs for splitting.
- PREHLS52/042001; PREHLS52/5 / 042031 and PREHLS7T/042011 splitters can accommodate
logs up to 52cm in length
- PREHLS7T/V/042021 splitter can accommodate logs up to 104cm in length.
The 3 support table positions allow the splitter to work on logs of 52cm, 78cm or 104cm in length.
Insert the support table in the position nearest to the log length, and secure the support table with the
locking hook.
When cutting up limbs and large sections, do not cut sections any longer than 100cm.
6. Apply a thin coat of grease to the surfaces of the ram before operation will lengthen the durability
of the ram.
7. Route the power cord.
Route the cord from the power source to the splitter in a way that safeguards against tripping on the
cord, or the cord becoming damaged during the work session.
Protect the power cord from impacts, pulling or corrosive materials.
8. Open the Air Bleed.
Loosen the oil tank
Retighten this cover when you finished.
9. While operating under extremely low temperature, keep the log splitters running under no load for
15 minutes to preheat the hydraulic oil.
5.3.1- For PREHLS7T/V/042021
a) Set wedge ram stroke, according to the following steps:
cover a few turns whenever the splitter is being used.