Maintenance - Power Stroke PSL1PS21 Manuel D'utilisation

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
LONG-TERM STORAGE
When storing the paint sprayer for 16 hours or more, a thor-
ough cleaning is recommended.
 Shut down the paint sprayer using Release Pressure
Procedure.
 Thoroughly clean paint sprayer and DUAL-ACTION
pistol-grip sprayer following the instructions in Cleaning
the Sprayer earlier in this manual.
 Be sure that machine and tubes are clear of any water or
fluid, as these may freeze.
 Store hoses, pistol-grip sprayer, nozzle and tips in the
storage bag, if desired.
 Fold handle over front of tool.

MAINTENANCE

CLEANING THE DUAL-ACTION
GRIP SPRAYER FILTER
See Figure 18, page 20.
 Turn off the paint sprayer and relieve pump pressure.
 Check that Dual-Action
locked off.
 Remove the high pressure hose from the Dual-Action
pistol-grip sprayer.
 If attached, remove the air hose from the Dual-Action
pistol-grip sprayer.
 Using an adjustable wrench, turn the nut on the intake
tube counterclockwise.
 Remove filter from the intake tube, noting direction of
filter.
 Thoroughly clean filter container with water (for water
based paints) or Klean Strip
Thinner (for oilbased paints or varnish).
 If filter has any holes, replace with new filter. NEVER
puncture filter with any object.
NOTE: If replacing, use the following recommended filters
or equivalent: ACPC050F; ACPC100F, and ACPC150F.
 Replace filter in the intake tube, tapered end down facing
back of sprayer. Sprayer will not work if filter is improperly
inserted in the intake tube.
 Reassemble Dual-Action
order, tighten securely.
 Reattach high pressure hose to the Dual Action
grip sprayer, tighten securely.
CALIFORNIA PROPOSITION 65
™
WARNING:
This product, and the paints designed to be applied with
this product, may contain chemicals, including lead,
known to the State of California to cause cancer, birth
defects, or other reproductive harm. Wash hands after
handling.
Page 14 — English
PISTOL-
™
pistol-grip sprayer trigger is
™
Safer Green Formula Paint
®
pistol-grip sprayer in reverse
™
™
™
™
pistol