Power Stroke PSL1PS21 Manuel D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
Do not attempt to modify this paint sprayer or create
accessories not recommended for use with this paint
sprayer. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
TOOLS NEEDED
Adjustable wrench
INSTALLING THE WHEELS
See Figure 3, page 18.
To attach the wheels to the base:
 Locate the axle.
 Slip the axle through the wheel hole.
 Lifting the paint sprayer slightly, slide the axle and wheel
into the wheel mounting hole in the machine base.
 Push the hitch pin into the hole on the end of the axle to
secure assembly.
 Repeat with the second wheel assembly.
FOLDING THE HANDLE
See Figure 4, page 18.
 To raise the handle: pull the handle up until the handle
release knob snaps through the locking hole to secure
the handle in place.
 To lower the handle (for storing): pull the handle release
knob on the right side of handle and lower.
WARNING:
Never use the handle to lift the paint sprayer. Failure to
heed this warning could result in serious personal injury.
ASSEMBLY
CONNECTING HIGH PRESSURE HOSE/
DUAL-ACTION
See Figure 5, page 18.
To connect the high pressure hose to the paint sprayer:
 Screw the collar of the high pressure hose onto the paint
connect outlet located on the control panel.
 Tighten securely with an adjustable wrench.
To connect the DUAL-ACTION
the high pressure hose:
 Screw the collar on the high pressure hose onto the
pistol-grip sprayer by turning the hose collar clockwise.
 Use an adjustable wrench to turn and tighten the nut on
the hose end and tighten securely.
INSTALLING NOZZLE TIP GUARD ON
DUAL-ACTION
See Figures 6 - 7, page 18.
See operator's instructions for flushing, priming, and clean-
ing before installing a spray tip. Note all warnings regarding
use of DUAL-ACTION
of injection.
 Push the lock-off lever down to lock the sprayer trigger.
 Unscrew the nozzle tip guard.
NOTE: Small parts inside the tip guard can be easily
dropped and misplaced. Always remove the nozzle tip
guard carefully.
 Insert the desired reversible spray tip into the nozzle tip
guard, locking the sleeve into place.
 Insert metal saddle into the nozzle tip guard. The metal
saddle should be securely seated on the reversible spray
tip.
 Insert the rubber seal ridged side down onto the saddle
in the nozzle tip guard.
 Thread nozzle tip guard assembly onto sprayer and tighten
securely.
 Push spray tip securely into nozzle tip guard.
 Keep the sprayer trigger locked when not in use.
Page 9 — English
PISTOL-GRIP SPRAYER
pistol-grip sprayer to
PISTOL-GRIP SPRAYER
pistol-grip sprayer and the possibility

Publicité

Table des Matières
loading

Table des Matières