EXTENSION CORDS
Use only 3-wire extension cords that have 3-prong grounding
plugs and 3-pole receptacles that accept the product's plug.
When using a paint sprayer at a considerable distance from
the power source, use an extension cord heavy enough to
carry the current that the product will draw. An undersized
extension cord will cause a drop in line voltage, resulting in
a loss of power and causing the motor to overheat. Use the
chart provided below to determine the minimum wire size
required in an extension cord. Only round jacketed cords
listed by Underwriter's Laboratories (UL) should be used.
**Ampere rating (on product data plate)
0-2.0
2.1-3.4
Cord Length
Wire Size (A.W.G.)
25'
16
16
50'
16
16
100'
16
16
**Used on 12 gauge - 20 amp circuit.
NOTE: AWG = American Wire Gauge
When working with the product outdoors, use an extension
cord that is designed for outside use. This is indicated by
the letters "W-A" or "W" on the cord's jacket.
Before using an extension cord, inspect it for loose or exposed
wires and cut or worn insulation.
PRODUCT SPECIFICATIONS
Flow Rate ............................................................ 0.31 GPM
Fluid Pressure ............................................... 800-3,000 PSI
Air Pressure ........................................................... 8-10 PSI
KNOW YOUR AIRLESS PAINT SPRAYER
See Figure 1, page 17.
The safe use of this product requires an understanding of
the information on the product and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all op-
erating features and safety rules.
3000 PSI PISTON PUMP
Maintains pressure as needed for different applications.
50 FT. HIGH PRESSURE HOSE
The 50 ft. high pressure hose allows the user to spray a larger
area without moving the paint sprayer.
ELECTRICAL
3.5-5.0
5.1-7.0
7.1-12.0 12.1-16.0
16
16
14
16
14
14
14
12
10
FEATURES
WARNING:
Keep the extension cord clear of the working area.
Position the cord so that it will not get caught on lumber,
paint sprayer, or other obstructions while you are working
with a paint sprayer. Failure to do so can result in serious
personal injury.
WARNING:
Check extension cords before each use. If damaged
replace immediately. Never use the product with a
damaged cord since touching the damaged area could
cause electrical shock resulting in serious injury.
14
ELECTRICAL CONNECTION
12
This product is powered by a precision-built electric motor.
It should be connected to a power supply that is 120 V, AC
—
only (normal household current), 60 Hz. Do not operate
this product on direct current (DC). A substantial voltage
drop will cause a loss of power and the motor will overheat.
If the product does not operate when plugged into an outlet,
double check the power supply.
Input ..................................120 V, AC only, 60 Hz, 15 Amps
Weight .......................................................................41 lbs.
BUCKET TRAY
Compatible with up to a 5-gallon container.
CONTROL PANEL
Single interface with all controls conveniently located.
DUAL-ACTION™ PISTOL-GRIP SPRAYER
The DUAL-ACTION™ pistol-grip sprayer easily switches
between airless and fine finish applications.
ELASTIC STRAP
Helps to secure the paint bucket to the body of the sprayer.
FINISH SPRAY TECHNOLOGY
The two-stage turbine delivers high volume, low pressure
(HVLP) spray for fine finish applications.
Page 7 — English