Power Stroke PSL1PS21 Manuel D'utilisation page 16

PROBLEM
Prime/spray lever is set to spray
but there is flow through the prime
tube
Pistol-grip sprayer leaks
Nozzle tip guard leaks
Pistol-grip sprayer will not spray
Paint pattern is weak or uneven
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 17
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
TROUBLESHOOTING
CAUSE
PRIME/SPRAY lever is dirty or damaged Contact Authorized Service Center
Internal sprayer parts are worn or dam-
aged
Nozzle tip guard or spray tip were as-
sembled improperly
Spray tip is clogged
Pistol-grip sprayer filter is clogged
Spray tip is not fully seated into nozzle
tip guard
Pressure is set too low
Pistol-grip sprayer or intake tube filter is
clogged
Intake tube is loose at inlet valve
Spray tip is worn
Material being sprayed is too thick
Loss of pressure
Page 16 — English
POSSIBLE SOLUTION
Contact Authorized Service Center
Reassemble according to nozzle tip guard
and Spray tip assembly instructions
Turn spray tip 180° and spray to clean
Clean or replace pistol-grip sprayer filter
Reassemble according to nozzle tip guard
and Spray tip assembly instructions
Turn variable pressure control to a higher
setting
Clean or replace filters
Tighten tube fitting
Replace spray tip
Follow material manufacturer's directions
and thin material as needed
See Cause/Possible solutions for Pressure
setting is too low, and Motor seems to
be running properly but pressure drops
when pistol-grip is triggered