Operation - Power Stroke PSL1PS21 Manuel D'utilisation

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in fluids entering your eyes resulting in possible serious
injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
ACCESSORIES
All accessories used with this product must be rated a mini-
mum of 3,200 psi. Ensure compatibility and fit before using
any accessory with this product.
WARNING:
Risk of fire or explosion − spray area must be well venti-
lated and away from spark of flames. Failure to heed this
warning could result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Exterior painting and staining of decks, outdoor furniture,
fences, siding, and interior/exterior spray-painting of
walls, cabinets, and doors.
WARNING:
To reduce the risk of injection NEVER change spray tip
without setting the lock-off on the pistol-grip sprayer and
never point sprayer at any part of the body, persons, or
unit itself. In case of skin injection, seek medical attention
immediately. Failure to heed this warning could cause
serious personal injury.
LOCKING THE DUAL-ACTION
SPRAYER
See Figure 6, page 18.
Always lock the sprayer trigger when you have stopped
spraying to prevent the sprayer from being bumped or trig-
gered accidentally and causing injection.

OPERATION

 Push the lock-off lever down to lock the sprayer trigger.
 Push the lock-off lever toward the handle to unlock the
RELEASE PRESSURE PROCEDURE
See Figure 8, page 18.
Always follow this procedure when shutting the airless/finish
paint sprayer OFF for any reason. This procedure releases
pressure in the high pressure hose.
 Push the lock-off lever down to lock the sprayer trigger.
 Turn HI/OFF/FINISH switch OFF.
 Turn prime/spray lever to PRIME. This releases pump
 Push the lock-off lever up to unlock the sprayer trigger
 Push the lock-off lever down to lock the sprayer trigger.
 Leave prime/spray lever in the PRIME position until ready
FLUSHING THE AIRLESS PAINT SPRAYER
Before using the paint sprayer for the first time or before
beginning a new project or changing colors, it is important
to thoroughly flush the paint sprayer of any storage fluid,
previous cleaning fluid, or material left in the system. Follow
instructions for Cleaning the Airless Paint Sprayer before
beginning any project.
SET UP AND PRIMING
See Figures 8 - 10, pages 18 - 19.
User must prime the unit before operating the sprayer. The
high pressure fluid hose should already be attached as de-
scribed in the Assembly section of this manual.
 Place desired paint container onto the paint tray.
 Secure container with elastic strap. Place 5 gallon con-
 Lock the sprayer trigger.
 Remove nozzle tip guard and spray tip from pistol-grip
 Place intake tube in paint container.
 Set return tube into a waste container.
PISTOL-GRIP
™
 Turn prime/spray lever to PRIME.
 Turn variable pressure control to PRIME.
 Plug in the paint sprayer.
 Press and release the Rapid Valve Release button to make
Page 10 — English
trigger.
pressure.
and point to inside wall of paint container releasing unused
paint or stain back into container. This releases pressure
in the hose and pistol-grip sprayer.
to spray again.
tainer lid on container.
NOTE: This unit will hold a 5 gallon or 1 gallon paint
container.
sprayer.
sure the check valve is clear.