Power Stroke PSL1PS21 Manuel D'utilisation page 5

 Do not use paint sprayer if switch does not turn it
off. Have defective switches replaced by an authorized
service center.
 Before cleaning, repairing, or inspecting, shut off the
motor, release pressure, and make certain all moving
parts have stopped.
 Avoid dangerous environment. Don't use in damp or
wet locations or expose to rain. Keep work area well
lit.
 Never direct a paint stream toward people or pets,
or any electrical device.
 Never start the machine if ice has formed in any part
of the equipment.
 WARNING: High pressure spray can be dangerous
if subject to misuse. The spray must not be directed
at persons, animals, electrical devices, or the machine
itself.
 Keep away from hot parts.
 Check bolts and nuts for looseness before each use.
A loose bolt or nut may cause serious motor problems.
 Before storing, allow the product to cool.
 Store in a cool, well-ventilated area, safely away from
spark and/or flame-producing equipment.
 When servicing use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
 Never use the sprayer without a spray tip installed.
 An injection injury can lead to possible amputation.
See a physician immediately.
SPECIFIC SAFETY RULES
Page 5 — English
 Never put your hand in front of the spray tip when in
use. Gloves will not always provide protection against
an injection injury.
 Wear protective clothing to keep paint off skin and
hair, along with a mask or respirator during use. Paints,
solvents, and other materials can be harmful if inhaled or
if they come into contact with the body.
 Always unplug the paint sprayer, shut the unit off
and release pressure before servicing, cleaning
the tip or guard, changing the tip, or leaving unat-
tended.
 Plastic can cause sparks. Never hang plastic to
enclose a spray area. Do not use plastic drop cloths
when spraying flammable materials.
 Do not spray outdoors on windy days.
 Do not attempt to clean or unclog the spray tip with
your finger.
 Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one
heavy enough to carry the current your product will
draw. A wire gauge size (A.W.G.) of at least 14 is
recommended for an extension cord 50 feet or less
in length. A cord exceeding 100 feet is not recom-
mended. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord. An un-
dersized cord will cause a drop in line voltage resulting
in loss of power and overheating.
 Save these instructions. Refer to them frequently and
use them to instruct other users. If you loan someone this
paint sprayer, loan them these instructions also.