Publicité
Materials and tools required
Twist drill, 1.5 mm Ø
Twist drill, 3.0 mm Ø
Twist drill, 4.0 mm Ø
Screwdriver, cross-point / slot-head
Allen key
Flat-nose pliers
Adhesives
White glue, e.g. UHU coll, Order No. 958.60
UHU plus schnellfest (fast-setting epoxy), e.g. Order No. 962
UHU hart (cellulose adhesive), e.g. Order No. 534.35
Low-viscosity cyano-acrylate ("thin cyano"), e.g. Order No. 5822
[Seite 11]
Adhesives for different materials
The table below gives a few examples of typical glued joints. It does not claim to be
comprehensive.
Materials
Wood to GRP
Metal to wood
Metal to GRP
Wood to wood
Balsa to plastic
Note
Before gluing parts to the fuselage it is essential to remove lingering traces of release
agent by roughening the joint surfaces with fine abrasive paper. Rub down the glossy
surface of the fuselage until it is matt, otherwise you will not obtain strong, durable
joints.
Important: be sparing with all adhesives, as it is very easy to add unnecessary
weight in this way. Excessive weight always has an adverse effect on a model
aircraft's performance and handling in the air.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler Id-Nr. 0059157
e.g. Order No. 574.1,5
e.g. Order No. 574.3
e.g. Order No. 574.4
e.g. Order No. 810
e.g. Order No. 105
Typical joint
Servo plate to fuselage
Nut to support plate
Wire latch to canopy
Dowel to wing
Horn to control surface
36
Adhesive, Order No.
UHU plus endfest, 950.43, or
UHU plus schnellfest, 962
UHU plus endfest, 950.43, or
UHU plus schnellfest, 962
UHU plus endfest, 950.43, or
UHU plus schnellfest, 962
UHU coll, Order No. 958.60, or
thin cyano, Order No. 5822
UHU hart, Order No. 534.35 or
thin cyano, Order No. 5822
04/2008
Publicité
