Elica NIKOLATESLA ONE BL/A/83 Prescriptions De Montage Et Mode D'emploi page 58

USING THE EXTRACTOR FAN
Power-on
Press (touch) ON/OFF hob/ extractor
The indicator light will turn on to indicate that the hob/extractor
is ready for use
Press again to turn off
Note: This function has priority over the others.
Switching on the extractor fan:
Touch (press) the Selection bar (6) to activate the extractor
fan
Extraction speed (power):
Touch and scroll along the Selection bar (6):
to the right to increase the speed (power) of the extractor fan
(0-10);
to the left to decrease the speed (power) of the extractor fan
(10-0);
Timer
Activation/Regulation of Timer function for the
extractor fan
•
Select the extractor fan (speed ≠ 0).
•
Press (8) to access the Timer function (from
any speed)
•
Regulate the duration of the Timer:
press the selector
down time
press the selector
shut-down time
the display (15) will show the countdown,
Note: on the side of the display of the extractor fan, with the
Timer in use, the following symbol will appear
When the timer has finished the countdown, there is an
acoustic signal (for 2 minutes, or it will stop when one of the
buttons on the hob is pressed), while the display (15) will
"
flash, with the symbol
To switch off the Timer:
•
select the cooking zone
•
set the value of the timer to " " , by means of
, to increase the automatic shut-
, to decrease the automatic
(19)
. ".
Not: the function remains active if no other key is pressed
in the meantime.
Filter saturation indicator
The hood indicates when it is necessary to perform
maintenance on the filters:
" "
the LED
Resetting activated carbon odour filter saturation
After performing maintenance on the filters, press and hold
the button (7) ; the LED
and the indicator countdown will start again.
Automatic mode
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the maximum cooking level used in the
cooking zone.
To activate this function:
Briefly press (7), the LED "
indicate that the hood is working in this mode.
Automatic hood mode with SNAP
For information on how to make the connection between the
hood and SNAP see the manual supplied with SNAP
®,
visit www.elica.com.
Note: SNAP is an auxiliary extraction unit able to operate at
®
the same time as the hood.
To activate this function:
Briefly press (7) , the LED "
"SNAP" (21) will light up to indicate that the hood is working in
this mode.
58
(17) will turn on
" "
(17) will turn off,
" (18) will light up to
®
" (18) and the LED
or
®