Scheppach SC36 Traduction Des Instructions D'origine page 21

Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment.
Troubleshooting guide
Fault
Motor does not start
Engine performance
drops
Imprecise scarifying
result
Motor is running, roller is
not rotating
Heruntergeladen von manualslib.de
Possible causes
• No electricity in plug
• Cable defective
• Switch, switch/plug block defective
• Connections to motor or capacitor
disconnected
• Housing clogged
• Soil is too firm
• Housing clogged
• Roller badly worn
• roller worn
• Wrong working depth
• Toothed belt is torn
Handbücher-Suchmachiene
By properly disposing of this product, you are also
contributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Rectification
• Check line and fuse
• Have machine checked by a customer ser-
vice center
• Have machine checked by a customer ser-
vice center
• Have machine checked by a customer ser-
vice center
• If necessary adjust working depth. Clean
housing so that the roller can run freely
• Change working depth
• Clean housing
• Replace roller
• Replace roller
• Correct working depth
• By customer service workshop
GB 21