Maintenance And Service - Dremel 3D20 Idea Builder Consignes De Sécurité/D'utilisation

DM 2610035691 07-14_3D20 7/3/14 2:41 PM Page 33
Problem
Extruder head building off
center
PL is not extruding or sticking
to the build tape properly
Dremel 3D software froze
during use or computer froze.
Dremel 3D20 froze before my
object started.
3D file loads with a warning
stating that the file is not
closed.
Support material does not
break away during cleaning and
results in decreased quality of
the final object.
Spaghetti mess at end of build.
Part only built halfway.
No filament coming out
Extruder will not home
Stringy or fraying plastic layers
on steep overhangs

Maintenance and Service

Cause
Dremel 3D20 has lost track of
the extruder head's exact
location and is failing to build.
This can be caused by the build
platform not being leveled with
the extruder head.
Sometimes software isn't as
smart as you are and locks up.
Dremel 3D20 may
received conflicting commands.
3D file has not been properly
designed and has
surfaces.
Orientation of the part is not
optimized.
layer of your object did not
stick properly, model was saved
with minimal surface area
contacting the build platform,
or object was built floating
above the build platform with
no support selected.
Filament ran out.
Filament clogged during build.
Clogged extruder
Limit switch wire failure
Object overhangs are too far
apart or too steep (<45degree
angle).
33
Corrective ction
Sending the extruder head to the
home position will recalibrate the
Dremel 3D20. Cancel your object,
clear build platform, send the
extruder head to the home position,
and restart the object.
Leveling the build platform will align
the extruder head and ensure a better
object quality. Cancel your object,
clear build platform, level the build
platform, and restart the object.
Save any open files if possible and
either restart the Dremel 3D software
or your computer.
have Turn power switch off, wait 30
seconds, and turn power switch on.
Open 3D file in a C D editing
open software to close all the open
surfaces.
Reorient the position of the 3D file in
Dremel 3D to minimize the support
material or place the support material
on a non-critical surface.
Use the preview future in Dremel 3D
to see the first layer height and
position. Build with supports when
necessary.
Replace filament and start build over.
See "No filament coming out".
Use unclog tool to push through
filament.
Contact customer service
Contact customer service.
Build with supports.