Contents
Five Important Safety Warnings ................. 3
9800 FlexFit plug
Reset button
Test button
Ground
fault unit
THERMAL buiLding SOLuTiOnS
Indicator
light
Gel-filled
end seal
EN-FrostexFreezeProtection-IM-H56581 12/14
Before You Begin
Make sure your Raychem Frostex 9800 FlexFit
Plug Kit is complete. It should contain:
1 9800 FlexFit plug
1 Push-on end seal
2 Orange warning labels
1 Installation instruction
Make sure you have sufficient braided
Frostex heating cable for the job. Do not
use earlier versions of Frostex heating
cable that have no braid. Also make sure
you have the following items:
#2 Phillips
screwdriver
Wire cutters
*Frostex 9610 application tape is recom-
mended.
Two 10-in (25 cm) plastic cable ties (not
included) may be used to secure ground-
fault unit to pipe insulation.
If you have any questions after reading this
guide, call this toll-free Pentair Thermal
Management number: (800) 545-6258.
Save this installation instruction and user
guide. It contains important safety warn-
ings and maintenance information.
1/2 in-1 in
(13 mm-25 mm)
tape*
2 / 10