Pentair Raychem FROSTEX 9800 Directives D'installation Et Guide D'utilisation page 5

step 2.
Install the end seal
Note: The end seal can only be used
once, so do not install it until step 2D.
Heating Cable Construction
2A. prepare the heating cable
Cleanly cut off one end of the heating cable.
2B. push the braid back
Push the braid back 1 in (25 mm) from
heating cable end.
2C. remove the plastic wrap
Cut and remove the clear plastic wrap. Do
not cut into the blue jacket.
THERMAL buiLding SOLuTiOnS
Clear plastic
wrap
Braid
1 in
(25 mm)
1 in
(25 mm)
EN-FrostexFreezeProtection-IM-H56581 12/14
Black core
(bus wires inside)
Blue jacket
2D. Install the end seal
Firmly push the end seal at least 3/4 in (2 cm)
onto the heating cable. Some gel may ooze out.
2E.
secure the braid
Slide the braid up against the end seal
and wrap it securely with a 4
strip of glass fiber or vinyl tape.
(10 cm)
-in
5 / 10