Jet JTSS-1700 Mode D'emploi page 5

Fig 4
Mount the scale carrier (W).
Mounting rip fence
Mount the rip fence to the rip fence
base rail.
Fig 5
Adjust the rack (X, Fig 4) so that the
micro adjust pinion (Y) engages nicely
(with little but not too much gear
space).
Mounting Sliding Table (JTSS-3200)
For access to blots remove the covers
(F and G).
With the help of another person lift the
sliding table (A) onto machine cabinet
and lock in place with screws (D),
washers and nuts (E).
Fig 6
The locating bolts (B and C) are
aligned ex works.
The sliding table must be aligned to
run parallel to the sawblade and
surface to be min 0,3mm higher than
the machine table.
Mounting Sliding Table Extension
See Fig 7
Fig 7
Mounting Crosscut Table
See chapter 7.7
Fig 8
5
Mounting Crosscut Fence
See chapter 7.8
Fig 9
Mounting Mitre Fence (JTSS-1700)
See chapter 7.9
Fig 10
Mounting Sawblade
See chapter 7.1
Mounting sawguard
See chapter 7.3
5.3 Dust connection
Before initial operation, the machine
must be connected to a dust extractor.
The suction should switch on
automatically when the saw is
switched on.
A hose, a Y-piece and a hose support
are supplied with the machine.
The flow rate on the suction port dia
100mm must be 20m/sec.
Flexible hoses must be of non-
flammable quality, and must be
connected to the machine ground
system.