Publicité
Les langues disponibles
Les langues disponibles
How to Attach to ATV's
If you are developing your own mount, follow these guidelines:
•
Spreader should be mounted to rear of vehicle, using ATV receiver hitch as main mount support.
•
Fabricate a mount bracket using a minimum of 2" x 11 gage square steel tubing that attaches spreader frame
to ATV hitch.
•
Use at least (4) 1/2" diameter bolts to mount spreader frame to square steel tubing.
•
Center spreader with Center Line of Vehicle. Do not offset to the Left or Right.
•
For additional support, use ratchet style tie straps to secure spreader frame to ATV Rear Cargo Rack.
•
Fabricate mount to accommodate the following dimensions:
Mount as close to ATV as
possible while allowing
linkages to work
Optional Hopper Extension Kit (Spyker Part #: 05-120-3600) is needed to increase hopper capacity to 4 cubic
feet. Extension may be used for lighter, fl uffy material, but total hopper capacity should not exceed 120 lbs. Do not
exceed 120lb of material in hopper on ATV's.
Handle extension
may be necessary
No front mount
Center spreader on
Locate and tighten
tie strap from
frame to rear cargo
rack (both sides)
22"
Mount to ATV
receiver hitch
7
ATV
1008754 Rev. A
Do not
mount high
Publicité
