Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
1. Remove spreader and components from carton
2. Place spreader upside down, with top of hopper
laying on a fl at surface.
3. If spreader will be mounted onto a ZTR and the Gate
Actuator Bracket (43) will be diffi cult to reach with
foot (See Figure 1), then the Gate Actuator Extension
(44) may be required. Install the Gate Actuator
Extension to the Gate Actuator Bracket using two
1/4"-20 x 1" Bolts (47) and two 1/4"-20 Nylon
Lock Nuts (31) as shown in Figure 2.
Figure 1
Hard to
reach
Figure 2
31
47
44
43
4. If spreader will be mounted onto a vehicle and you
will use your hand to open/close the gate actuator,
install the extension as explained in Step 3. If the
extension will not fi t in your particular application, it
may be necessary to fabricate a custom extension.
5. Turn Spyker Dial (8) to setting 9.9. Cut the cable
tie that is holding the Gate Actuator Rod (21) in
place. Slide the Gate Actuator Rod through the Gate
Actuator Bracket (43) into the position shown in
Figure 3.
6. Attach Gate Actuator Bracket (43) to the Frame
(39) using a 1/4" x 2-1/4" Bolt (50), two 1/4"
Washers (27), two Nylon Flange Bushings (49), and
a 1/4"-20 Nylon Lock Nut (31).
NOTE: Ensure that the Gate Actuator Bracket
(43) is assembled at the location and in the
orientation shown in Figure 3.
Figure 3
21
43
13
39
50
27
49
49
27
31
1008754 Rev. A
Publicité
