Publicité
Les langues disponibles
Les langues disponibles
Recommended Vehicles and
Attachment Method
If you have purchased an optional mount kit, follow
mount kit instructions for proper assembly of spreader
to vehicle. If a mount kit is not available for your vehicle,
and you are fabricating your own mount kit, please read
and understand the following.
This spreader is to be attached to 4 wheel vehicles only.
The following are the recommended types of vehicles
and minimum vehicle requirements needed to properly
mount the spreader. While signifi cant effort was made
to ensure that the recommended vehicles are safe for
operation, it is up to the operator to use the spreader
and vehicle with the following safe operating practices.
•
When spreader is attached to vehicle, be aware that
handling characteristics of vehicle may be affected.
To prevent loss of control when spreader is attached
to vehicle.
•
Read spreader Operators Manual.
•
Allow for longer braking distances.
•
Vehicle speed should be less than 10mph.
Speed should always be slow enough to
maintain control. If your vehicle manual
specifi es a speed slower than 10 mph when
carrying loads, then do not exceed specifi ed
speed.
•
Do not drive on slopes greater than 10
degrees.
•
Empty spreader hopper and travel slowly
while going up and down trailer ramps.
•
Do not drive on wet slopes. Slippery conditions
reduce traction and could cause loss of control.
•
Look behind machine before you back up. Back up
carefully.
•
Travel slowly over rough terrain.
•
Do not load spreader hopper with more than the
maximum weight capacity.
•
Evenly distribute loads in the cargo bed (UTV) or
cargo rack (ATV).
3
1008754 Rev. A
Publicité
