KTM Power Parts 78102924000 Mode D'emploi page 4

2
3
2
4
8
7
7
incorrect
1
Scope of supply:
1x right lock-on grip (1)
1
1x left lock-on grip (2)
1x A plate cam (4-stroke) (3)
1x D plate cam (2-stroke 85-300 cm³) (4)
1x E plate cam (2-stroke 50-65 cm³) (5)
NOTE:
Pay attention to the letters A, D or E on the plate cams.
5
4
Assembly
- Remove the left grip and push the left lock-on grip (2) onto the handle-
- Tighten the screw (6) (3-4 Nm, Loctite 243).
6
NOTE:
The basic procedure is the same for the different throttle grips of the 2-stroke
and 4-stroke variants.
- Remove the screws (7) and take off the throttle grip housing (8).
9
- Detach the throttle cable wire (2-stroke) or the throttle cable wires (9) (4-
9
- Remove the throttle grip.
- Mount the appropriate plate cam (3, 4 or 5) on the right lock-on grip (1).
correct
NOTE:
1
The plate cam must be mounted as shown in the figure.
- Push the right lock-on grip (1) with the plate cam (3, 4 or 5) on the hand-
8
- Attach the throttle cable wire (2-stroke) or the throttle cable wires (9) (4-
7
- Position the throttle grip housing (8) and tighten the screws (7) (for torque,
7
Final assembly
- Check that the throttle grip is functioning properly.
bar.
stroke).
lebar.
stroke).
see vehicle owner's manual).