The Handle; Changing To Another Lupo Unit (Accessory); Changing Lubricant Type / Refilling - Struers RotoForce-1 Mode D'emploi

The Handle

Changing to Another
Lupo Unit (Accessory)
Changing Lubricant Type /
Refilling
RotoForce-1
Instruction Manual
The handle of RotoForce-1 is used to move RotoForce-1 into an
upright position. In this position it is possible to exchange
specimen mover plates and preparation discs. As RotoForce-1 is
equipped with a gas spring, it will be moved upwards
automatically after the handle is moved backwards.
To move RotoForce-1 down again, simply press it down until the
locking pins engage in the bottom plate.
n Set the mode switch on Lupo to STOP
n Remove the current Lupo.
n Place the other Lupo (accessory) with an alternative lubricant
in the connector on the supporting arm.
n Set the mode switch on Lupo to STOP
n Remove Lupo from RotoForce-1.
n Hold the Lupo lubricant bottle firmly and remove the top lid.
n Empty the bottle, still mounted on Lupo, of any remaining
lubricant.
−
Fill the bottle with mild, soapy water.
−
Put Lupo back on the supporting arm.
−
Set the mode switch on Lupo to START
−
Set the dosing control to max. dosing (step 10) and let the
water run through the nozzle for 2-3-min.
Repeat the above points but fill with tap water to rinse out
any soap residue.
n Refill with lubricant and remount the top lid.
Always avoid turning the socket cap while unscrewing the Lupo bottle, as the
turning movement may cause damage to the socket cap gasket.
o
position.
o
position.
IMPORTANT
s
.
11