Sentiotec WORLD OF WELLNESS wave.com4 Instructions De Montage Et Mode D'emploi page 66

Instructions for use for the user
The automatic function of the Wave.com4 sauna control unit is active when the
8 a
and symbols illuminate. The operating unit display now shows you the
remaining time in hours until the Wave.com4 sauna control unit starts the ope-
rating mode pre-programmed by you.
2. Automatic switch-off
Activate the main switch which disconnects the Wave.com4 sauna control unit
from the mains at all poles after use. The
The automatic switch-off can be automatically programmed by simultaneously
pressing (3 secs.) the
5
12) with the und
3. Temperature rectification
The use of components WC4-B-L, WC4-B-F1, WC4-H-PCB and WC4-H-F2 is
recommended for the Finnish sauna for exact temperature regulation!
TIP!
Using these components enables your Wave.com4 sauna control unit to
regulate according to an exact temperature value (regulation according
to the bench sensor).
TIP!
When only using the components WC4-B-L and WC4-B-F1 for the Finnish
sauna, the Wave.com4 sauna control unit only regulates according to
the heater sensor. The temperature measured above the heater deviates
from the temperature on the bench.
WORLD OF WELLNESS
5 4
and keys. Now set a time interval in hours (1 to
keys. Confirm your selection with the
6
8
on the operating unit illuminates.
p. 24/42
4
key.