Connection To The Drain Line; Adjustments And Checks; Rinse-Aid Dispenser - Diamond D604-EKS Mode D'emploi

GB
Hardness
Residual
Minerals
A
B
Specification
French degrees
German degrees
English degrees
Parts per million
Maximum
2.4
The tank empties by gravity, so the drain needs to be
situated below the base of the machine.
The drain pipe needs to be connected to a drain- trap built
into the floor.
The drain dimensions are shown in the installation drawing.
The temperature of the wash tank is regulated by a fixed thermostat at
about 55° C. This temperature ensures proper action by the chemicals
contained in industrial dishwashing detergents.
The boiler temperature set by a fixed thermostat is about 85° C.
Before adjusting,
using the primer button (A).
To adjust use the ring nut (B) situated at the center of the
dispenser, rotating
counterclockwise increases it.
The dispenser must not operate empty
An excessive amount of rinse agent causes bluish stripes on the
dishes and creates foam in the wash tank.
From
f
°dH
°e
ppm 70
mg/l

CONNECTION TO THE DRAIN LINE

2.5

ADJUSTMENTS AND CHECKS

2.6

RINSE-AID DISPENSER

the dispenser and hose need to be filled
clockwise reduces
Pag. 5
To
5 10
4 7'5
5 9,5
140
300/400
the quantity,