Informative Labels; Installation; Electrical Connection; Technical Data For Electrical Connection - Diamond AMHF/312-P Instructions Pour L'installation

EN

1.4 INFORMATIVE LABELS

On each prover there are applied some metal labels, that give important info concerning characteristics.

INSTALLATION

1.5 POSITIONING OF THE PROFER
The place where the prover will be installed must comply the following requirements:
• Be protected from atmospheric agents and have an adequate air circulation;
• Comply with regulations concerning safety at work;
• Have a room temperature between 5 °C and 35 °C with a humidification not higher than 70%.

1.6 ELECTRICAL CONNECTION

When the appliance is delivered it is set to work at the voltage given on the rating plate affixed on the right side
of the appliance.
The Manufacturer declines all and every responsibility if this important accident prevention norm is not complied
with.
If the feeding cable is damaged, it must be replaced by the technical service or in any case by similar qualified
personnel, in order to avoid any risk.

1.7 TECHNICAL DATA FOR ELECTRICAL CONNECTION

Model
8 x 2/3 GN - 8 x 46x34
8 x 60x40
6+6 x 60x40
8+8 x 60x40
Provers are supplied with electric power cable included.
On the right hand side panel there is the label A.
The info contained on this label are:
• Name and address of the manufacturer
• Prover model
• IPX protection grade against water jet.
• Conformity to EC directives.
• Power input and power supply (single or three phase).
• Serial number of the prover
• Symbol of European Directive 2012/19/UE
Power loading and voltage
2.7 kW 220-240 V 1N ~ 50/60 Hz
2.7 kW 220-240 V 1N ~ 50/60 Hz
3.2 kW 220-240 V 1N ~ 50/60 Hz
3.2 kW 220-240 V 1N ~ 50/60 Hz
If an oven is placed over the prover, make
sure the centre hole of the feet snap on
to the support pin which will guarantee
stability.
Heating power
1.5 kW
2.0 kW
2.0 kW
2.0 kW
8
Absorbed current
6.5 A
8.7 A
8.7 A
8.7 A