Troubleshooting - Reely SKY 23 26 60 Mode D'emploi

9. t
roubleshootIng
Even though the model and the remote control system were built with state-of-the-art technology, malfunctions or breakdowns can occur.
For this reason, we would like to show you how you can remedy possible breakdowns.
Problems with the RC system
Problem Solution
• Transmitter or receiver batteries are empty
• Batteries are inserted in the wrong manner
• Connector of the receiver batteries is loose
RC system is not functioning
• Replace the transmitter and/or receiver batteries
• Check the polarity of the batteries
• Firmly insert the connector again
• Transmitter and/or receiver batteries are weak
• Transmitter antenna is not pulled out
• Receiver antenna is not extended to its full length
• Receiver antenna has been cut
Range of the transmitter to low
• Replace the transmitter and/or receiver batteries
• Pull the antenna all the way out
• Pull the antenna wire all the way out
• Have the receiver repaired
• Transmitter and/or receiver batteries are weak
• Cogwheels in the servo-drive don't catch or are defective
• Adjusting rings on the adjustment levers are loose
• Servo-reverse switch on the transmitter was mistakenly turned to "REV"
Servos do not respond properly
• Replace the transmitter and/or receiver batteries
• Have the servo repaired
• Set the adjusting rings again, using the factory placements
• Turn the servo-reverse to "NORM"
• Receiver quartz is loose
• Connector of the receiver battery is loose
• Receiver is damaged, e.g., after a crash
• One or more electrical / electronic components have come into contact with moisture
• Insert the receiver quartz again
RC system is defective
• Firmly insert the connector again
• Have the receiver repaired
• Let the model / the components thoroughly dry out for several hours (overnight) in a
warm place.
• If necessary, have the part repaired.
Problems in flight operations
Problem Solution
• Flight battery is not completely charged
• Transmitter battery is not completely charged
• The circuit has been interrupted (e.g., after a crash)
• Transmitter and receiver quartz do not match
• Motor is broken
• Drive cogwheel is jammed
The model does not respond
• Charge the flight battery
• Charge the transmitter battery
• Restore the connexion
• Change to an appropriate quartz pair
• Replace the motor
• Check the alignment of the drive cogwheel
• Swashplate is linked
• Gyro is defective or calibrated wrongly
Model doesn't fly straight ahead • Correct the swashplate position on the corresponding trim lever of the remote control
transmitter
• Replace the gyro oder or recalibrate it
• Flight battery is not completely charged
Model does not climb
• Charge the flight battery
28
4. d
escrIPtIon du modèle
1. v p l'
érificatiOn de la Ortée de éMetteur
Emetteur 4 canaux télécommandé
Emetteur portatif avec deux leviers de télécommande, chacun avec deux fonctions
Ces fonctions sont contrôlées par des mouvements avant / arrière / et droite / gauche.
Antenne télescopique
Affichage DEL
(état de charge)
vert : accus pleins
jaune : remplacer les accus
rouge : accus vides
Interrupteur non utilisé
Canal 2 : longitudinal
(force ascensionnelle)
Canal 4 : Rotor arrière
(direction)
Levier de trim du rotor arrière
Levier de trim longitudinal
Interrupteur MARCHE/ARRET
Interrupteur DIP
(inversion de la course des servos)
Prise de raccordement à un ordinateur
pour programme de simulation de vol
Compartiment des piles
r/c
Interrupteur à bascule non utilisé
Interrupteur non utilisé
Canal 1 : « roulis »
(aileron)
Canal 3 : « tangage »
(profondeur)
Levier de trim « roulis »
Levier de trim « tangage »
Quartz d'émission
Prise de charge
Support d'accu
33