2.2.3 Setting the Running
Characteristics Parameters
1. Removing the body (=> page 41).
2. The respective running characteris-
tics can be changed by changing
the setting on the potentiometers.
These potentiometers have a stop
at the end positions. When you
encounter resistance when turning
the "pots", do not try to turn them
further with force.
P1: Acceleration / braking delay
(together)
Left stop: minimum delay
Right stop: maximum delay
P2: Maximum speed
Left stop:
lowest maximum speed
Right stop:
highest maximum speed
Important:
Do not confuse the two potentio-
meters for setting the running
characteristics on the digital circuit
board with the potentiometer for
adjusting the volume of the sound
effects on the circuit board.
P1
P2
2.3 Operations with
Individual Power Systems
The model is designed for optional
operation with Märklin Systems
(Mobile Station or Central Station),
Märklin Digital (only with the
Control Unit as a Central Unit),
Märklin Delta, AC power (only with
the Märklin Transformer 32 VA), or
DC power (power pack with a maxi-
mum voltage of +/– 18 volts DC).
Damages caused by operating the
locomotive with another operating
system will be viewed as taking place
in a non-authorized operating status
and therefore are not covered by the
manufacturer's warranty. The con-
sumer assumes all responsibility for
damages resulting from this situation.
2
Operation
2.3.1 Operation with the Mobile
Station / Central Station
Please read the instructions for the
Mobile Station or Central Station to
enter this locomotive into the loco-
motive list. Please use the item num-
ber for the locomotive found on its
packaging to call it up from the data-
base. The following auxiliary func-
tions are available on this locomotive:
• Turning headlights on/off that
change over with the direction
of travel
• Turning locomotive operating
sounds (motor, auxiliary appliances,
etc.) on/off
• Sound effects for a locomotiv
whistle on/off
• Sound effects for a locomotive bell
on/off
• Smokegenerator on/off
19