Control Input/Output; Computer System Requirements; Windows; Mac - Tascam Model 24 Mode D'emploi

Control input/output

FOOTSWITCH jack
Connector: 6.3mm (1/4") standard TS jack (Tip: HOT, Sleeve:
GND, Unlatch type correspondence)
USB port
Connector: 4-pin USB B-type
Protocol: USB 2.0 HIGH SPEED (480 Mbps)

Computer system requirements

Check the TEAC Global Site (http://teac-global.com/) for the
latest information about supported operating systems.

Windows

Supported operating systems
Windows 10 32-bit
Windows 10 64-bit
Windows 8.1 32-bit
Windows 8.1 64-bit
Windows 7 32-bit SP1 or later
Windows 7 64-bit SP1 or later
(Windows 8, Windows Vista and Windows XP are not supported)
Computer hardware requirements
Windows computer with a USB 2.0 port
CPU/processor speed
2 GHz or faster dual core processor (x86)
Memory
2 GB or more
ATTENTION
Operation of this unit was confirmed using standard com-
puters that meet the above requirements. This does not
guarantee operation with all computers that meet the above
requirements. Even computers that meet the same system
requirements might have processing capabilities that differ
according to their settings and other operating conditions.

Mac

Supported operating systems
macOS Mojave (10.14 or later)
macOS High Sierra (10.13 or later)
macOS Sierra (10.12 or later)
OS X El Capitan (10.11 or later)
Computer hardware requirements
Mac with a USB 2.0 port
CPU/processor speed
2 GHz or faster dual core processor
Memory
2 GB or more
14 – Specifications

iOS device

Operation has been confirmed with Apple devices running the
following iOS versions.
iPadOS13
iOS13
iOS12
iOS11
ATTENTION
To connect an iOS device that has a Lightning connector, a
genuine Apple Lightning to USB Camera Adapter (sold sepa-
rately) is necessary.

Supported audio drivers

Windows
ASIO2.0, WDM
Mac
Core Audio
iOS divice
Core Audio

Audio performance

Noise
Residual output noise (22kHz, A-weighted)
MAIN MIX OFF: -100 dBu
MAIN MIX -0dB, 1ch-0dB: -80 dBu
Equivalent input noise (EIN)
-128 dBu (Rs=150 Ω, MIC IN w INSERT SEND, gain knob at
MAX, A-weighted)
Total harmonic distortion ratio (THD+N)
(gain knob at MIN, 1kHz)
MIC IN w MAIN OUT: 0.01% or less
MIC IN w MAIN OUT: 0.004% @+4dBu
Frequency response
(All GAIN knobs minimized, 1 kHz)
20 Hz to 30 kHz (+0.5/–1.0 dB, analog)
20 Hz to 20 kHz (+0.5/–1.0 dB, digital)
Crosstalk
(PAN knobs turned completely left or right, 1 kHz)
Between channels: -80 dB
Between input and output: -80 dB
Maximum gain
(All GAIN knobs maximized, PAN knobs turned completely
left or right, EQ knobs and STEREO GRAPHIC EQ faders at
middle positions)
MIC w MAIN OUT: 74 dB
MIC w INSERT OUT: 54 dB
MIC w SUB OUT: 74 dB
MIC w CONTROL ROOM OUT: 79 dB
MIC w MONITOR OUT: 75 dB
MIC w FX OUT: 75 dB
USB/SD w MAIN OUT: 24 dB
Phantom Power
+48V
63
TASCAM Model 24