Time And Date Settings; Turning Bezel; Notes On Avoiding Scratching Your Watch And The Bands; Changing The Watch Band - Auriol 2-LD4286 Utilisation Et Avertissements De Sécurite

Time and date settings

To set the time, carefully pull the crown out all the way. Turn the crown clockwise
or counter clockwise to set the time. Carefully press the crown back in halfway to
the case. The date can be set by turning the crown. To finish the setting press the
crown back in all the way.

Turning bezel

2-LD4286-2
Notes on avoiding scratching your watch and the
bands
Place your watch/band on a soft surface to avoid scratching the watch/band
while changing or shortening the band.

Changing the watch band

Use the forked end of the included tool to compress the
spring bar far enough so that the band can be removed.
Please note that the spring bar can easily jump from the band
and get lost. Now insert one end of the replacement band
into the opening between the case lugs of the watch. Use the
fork end of the included tool to compress the spring bar far
enough so that the other end of the spring bar can be
inserted into the opposite opening. Lightly tug at the band to
check if the ends of the spring bar have snapped into the
openings on the case lugs.
Band shortening instruction for models
2-LD4286-2, 2-LD4286-5
Band shortening can be accomplished by removing links. Open the band clasp
safety and open the clasp. The band is held to the clasp by a spring bar. Image
1. Compress and remove the spring bar by using a pointed tool. Now place the
watch face down on a soft surface. Image 2. The links that can be removed are
marked with an arrow. Image 3. Place the band in the band changing tool in
such a way that the pointed end of the tool points directly at the metal rod and the
metal rod can be pushed out in the direction of the arrow. Carefully turn the screw
clockwise until the metal rod is pushed out a small distance. The rod can now be
pulled out (using pliers if necessary). The strap can now be taken disassembled.
Remove as many links as necessary using this method. Reinsert the rod in the
Turning
bezel
- 24 -