Attaching The Container; Mode Of Operation - Gesipa PowerBird Pro Gold Edition Mode D'emploi Avec Pièces De Rechange

2.6.1 Attaching the container

Screw on the spent mandrel container (H) as far as it will go (turning it to the right).

2.6.2 Mode of operation

The blind riveting tool features optimised operating speed. After inserting the blind rivet, the
blind riveting tool can be operated in two different modes:
a. Pressing and holding the switch (G):
Press and hold the switch (G) to start riveting. The pulling process stops automatically when
the rivet reaches the rear end position. The tool automatically assumes the front starting posi-
tion when the switch (G) is released.
b. Tapping the switch (G):
Riveting is triggered by briefly tapping and immediately releasing the switch (G). As soon as
the mandrel breaks off, the blind riveting tool stops and automatically re-assumes the front
starting position.
• Eject the spent mandrel by tilting to the rear into the spent mandrel container or to the
front through the nosepiece.
• The blind riveting tool is equipped with overload protection. In the event of overloading
the blind riveting tool, e.g. by setting rivets that are outside the working range, riveting
stops, indicated by the 3 LEDs flashing slowly (1 Hz). Press the switch to make the blind
riveting tool go back to the start position and it is then ready for operation.
• The control detects a blockage on return (e.g. dirt, foreign object, etc. in the steel head
sleeve). The tool stops the return procedure and immediately assumes the rear end posi-
tion automatically. The fault is indicated by the LEDs flashing rapidly (2 Hz). The battery
pack must be removed and the fault eliminated. Then reinsert the battery and briefly
press the switch. The tool assumes the front end position and is again ready for use.
• The blind riveting tool is fitted with an acoustic warning device, which provides information
about the remaining battery time. Beeps sound to tell the user when to change the battery.
This ensures that the blind riveting tool will not switch off during a riveting operation.
3 beeps and flashing LED lights for 10 seconds:
The battery needs to be changed soon (about 20% battery charge remaining).
6 beeps and flashing LED lights for 10 seconds after every setting sequence:
Change the battery after a few more riveting sequences in order to guarantee safe riveting
sequences (approx. 10% battery remaining).
9 beeps and flashing LED lights for 10 seconds: The next riveting sequence cannot be
reliably carried out. The blind riveting tool is switched off. Change the battery.
GB
19