Lighting; Maintenance - Gesipa PowerBird Pro Gold Edition Mode D'emploi Avec Pièces De Rechange

GB

2.6.3 Lighting

The blind riveting tool is equipped with 3 LED lights to illuminate the work space. These can
be turned on by turning the black ring (F) behind the LEDs. There are 3 settings, which are
displayed by an arrow cast in the housing.
— Continuous light/torch function:
The lighting is switched on after a riveting sequence and stays on for
approx. 10 minutes. The LEDs then turn off automatically.
•
Lights switched off.
-- Work light:
Lights are switched on at the start of the riveting sequence. The LEDs stay
on for about 10 seconds and then switch off automatically.
2.7

Maintenance

The maintenance of the blind riveting tool is limited to the complete claw mechanism and the
associated wearing parts:
• Remove battery from the blind riveting tool.
• Unscrew the head (B) using flat wrench SW 14 or SW 24 and clean. Look for deposits in
the top of the head!
• Unscrew the jaw housing (C) using 2 SW 17 flat wrenches.
• Take out the jaws (D) and jaw pusher (E), clean them and lubricate or grease the sliding
surfaces; replace the jaws (D) if worn (blunt teeth!).
• Re-assemble in reverse order ensuring that all parts are tightened! We recommend that you
secure the screw connection using a thread adhesive (such as Loctite 222 or Loctite 243).
Regular maintenance will extend the service life of your high-quality GESIPA
and they should be serviced at least every 2 years by an authorised workshop or by
GESIPA Service. For tools that are used intensively, we recommend servicing ahead of
®
schedule.
20
Zero position:
tools
®