effegibi Logica Manuel D'utilisation Et D'entretien page 74

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
TROUBLE-SHOOTING
Please note: the information in the table below and the action to take is intended for the use
of the assistance centre personnel and others qualified to install/maintain the equipment.
Error message
Error 1
Error 2
Error 3
Error 4
Error 5
Error 6
For any situations not covered in this table, consult your approved assistance centre or contact the company
direct.
72
The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes without having to give prior warning or
LOGICA OPERATING AND MAINTENANCE MANUAL
Meaning
No
dialogue with an
element
recognised.
The control panel is
not in dialogue with
the other electronic
elements.
Boiler full too soon. The
Boiler not yet full.
Boiler
not
empty.
New peripheral
device recognised.
Error
software
Lack of
communication
already
with 1 or more
devices.
Lack of
communication
with 1 or more
devices.
boiler
filled
too quickly during
initial rinsing or final
emptying.
The boiler didn't
fill
within
the
prescribed
time
limit
during initial
rinsing
or
final
emptying.
yet
The water level in
the boiler remained
too high for too
long during initial
rinsing
or
final
emptying.
replace this manual.
Cause
Solution
One of the devices
1. Check the device
is
not
receiving
connections.
power or is not
2. Run the start-up
connected.
sequence.
One of the devices
1. Check the device
is
not
receiving
connections.
power or is not
2. Run the start-up
connected.
sequence.
Outlet
valve
not
1. Check that the
working.
outlet path is clear.
2. Check that the
steam pipe is not
obstructed, bent or
is not siphoning.
3. Clean the outlet
valve.
Lack of water in
1. Check that the
the system or the
water tap is turned
inlet valve filter is
on.
blocked.
2. Check that there
is
water
system.
3. Check that the
filter at the entrance
to the inlet valve is
not blocked.
Outlet
valve
not
1. Check that the
working.
outlet path is clear.
2. Check that the
steam pipe is not
obstructed, bent or
is not siphoning.
3. Clean the outlet
valve.
A new component
1. Check
has been
connections and
connected to the
power cabling.
product.
2. Run the start-up
sequence.
in
the

Publicité

Table des Matières
loading

Table des Matières