Cleaning And Maintenance; Hammam/Turkish Bath Routine Maintenance - effegibi Logica Manuel D'utilisation Et D'entretien

11.

CLEANING AND MAINTENANCE

Before performing any cleaning and/or maintenance operations the
unit must be disconnected from the power supply and the water inlet
tap must be turned off.
CLEANING THE HAMMAM/TURKISH BATH STEAM GENERATOR
(only for the products Logica Twin, S+H Twin, Logica Hammam, H-One)
The front panel of the generator is made of toughened glass and therefore during cleaning all the precautions
necessary for glass must be taken.
Clean the column with a soft cloth, using water and possibly a neutral detergent, particularly on the varnished
border to the side.
Do not use sharp or abrasive tools that may cut or scratch the seals and the varnished surfaces.
11.1

HAMMAM/TURKISH BATH ROUTINE MAINTENANCE

Maintenance must only be performed by qualified personnel.
Before gaining access to any of the internal parts, disconnect from the electricity and water
mains.
In all circumstances, maintenance must be performed in compliance with the safety regulations
that apply to the installation site.
EFFEGIBI® steam generators have been designed to need little maintenance.
However, every six months, or more often in hard-water areas (over 30 French degrees), inspect
- the inlet and outlet valves;
- the boiler.
Remove any deposits such as lime scale and other impurities produced by boiling water.
The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes without having to give prior warning or
LOGICA OPERATING AND MAINTENANCE MANUAL
replace this manual.
EN
67