Unit Description; Initial Use - Beurer IL 35 Mode D'emploi

• Do not pull the mains plug from the socket by the cord.
• In the event of a defect or malfunction, switch the device off immediately and disconnect it from the power
supply.
• If the power cord of the device is damaged, it must be replaced by the manufacturer or an authorised
customer service technician in order to avoid hazard.
• Disconnection from the mains supply is only guaranteed if the mains plug has been removed from the socket.
• There is a risk of strangulation for babies and children who become trapped in the mains cable.
General notes
Important
• Product is not suitable for lighting rooms in private homes.
• This unit is not intended for commercial or clinical use, but only for individual, private household use!
• If you have health concerns of any kind, contact your general practitioner!
• Before you use the unit for the first time, remove all packaging materials.
• Lighting is excluded from the warranty.
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. Unit description

1
6
5
3
4

5. Initial use

Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use,
check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an
adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
Replacing the fuse (UK plug only)
If the fuse needs replacing, please observe the following:
• Remove the mains plug.
1. Light source
2
2. Lamp shade
3. Base
4. On/Off button + timer button
5. LED timer indication
6. First LED = readiness indicator/standby
9