Operation; Important Instructions - Beurer IL 35 Mode D'emploi

• Lift out the fuse holder from the inside of the mains plug using a flat screwdriver.
• Pull out the fuse from the fuse holder and replace it with a new fuse type: 3A (breaking capacity 6 kA at 240 V)
in accordance with BS-1362 / SS167.
• Press the fuse holder containing the new fuse into the plug slot.
• Plug the mains plug into the socket and test to see if it works.

6. Operation

1 Switching on the lamp
 To connect to the mains, fully insert the plug into the socket. Once inserted, the „5 min" LED will
flash. This is the readiness indicator (standby). Press the On/Off button (4) once to switch on the lamp.
2 Enjoying the light
The recommended duration of treatment is maximum 15 minutes and should be limited to a ma-
ximum of two treatments a day. We recommend selecting a shorter radiation period to start with.
However, the skin of some people may show an over-sensitive (e.g. with extreme redness, blistering,
itching, heavy sweating) or allergic reaction to heat radiation, even when the lamp is used correctly.
3 LED display/timer
The IL 35 infrared lamp indicates your current treatment time with the aid of 3 LEDs.
The treatment time can be set at the following 3 levels.
To scroll through the timer, hold down the On/Off button (4) until the required timer level lights up.
The levels are as follows:
Treatment time
5 minutes
10 minutes
15 minutes
The lamp switches off automatically once the set treatment time has elapsed. To switch off the lamp
manually, repeatedly press the On/Off button (4) until only the „5 min" LED is flashing, the other LEDs
are off and the lamp goes out.
4

Important instructions

The distance between the infrared lamp and the radiated part of the body should not be less than the
following: at least 32 in (80 cm)
Protective eyewear which corresponds to the requirements of DIN EN 171 2002 must be worn for
treatment distances under 80 cm.
For treatment distances above 80 cm, closing your eyes is sufficient.
CAUTION: Never look directly into the infrared light without protective eyewear.
Basically,
examine the radiated section of the body regularly. Discontinue radiation immediately if any signs of
an over-sensitive or allergic reaction appear and consult a physician.
5 Switching off the lamp
CAUTION!
The lamp is hot after being used. Let the lamp cool off first long enough before you put it away and/
or pack it up!
Please note that the mains cable must not be wound round the infrared lamp either for storage or
when in use.
Disconnect the mains plug from the socket to fully switch off the device.
Number of lit LEDs
1
2
3
10