Unit Description; Initial Use - Beurer MP 48 Mode D'emploi

6. Unit description

1� Mains adapter
2� ON/OFF button with three timer levels (30, 60 and 120 seconds)
3� Side air vents
4� Fan
5� Female connector
1

7. Initial use

Note
• Check to ensure that the package contains all the parts that should be included in the delivery� If any parts
are missing or damaged, contact Customer Services�
• Remove all packaging material�
WARNING
Keep packaging material away from children to avoid danger of suffocation�
8. Usage
1� Place the device on a firm, level and dry surface� Ensure that the fan on the bottom and the side air
vents are NOT covered!
2� Insert the mains adapter into a suitable socket according to the technical data on the mains adapter�
3� Insert your hand/foot with the nails treated with UV/LED nail gel into the open-
ing of the device (with the nails facing upwards)�
4� Press the ON/OFF button to switch on the nail dryer�
5� Select the desired application duration (30, 60 or 120 seconds) using the ON/
OFF button� Set the application duration according to the recommended set-
ting time of the UV/LED nail gel manufacturer� The device then switches off
automatically after the programmed setting time has been reached� Dry your
treated nails on the other hand/foot as described in this chapter�
Press the ON/OFF button once
Press the ON/OFF button twice
Press the ON/OFF button 3 times Application duration = 120 seconds ON/OFF button lights up red
Press the ON/OFF button 4 times The nail dryer turns off
6� Pull the mains adapter out of the socket after each use� Allow the nail dryer to cool down completely�
2
Application duration = 30 seconds ON/OFF button lights up blue
Application duration = 60 seconds ON/OFF button lights up green
4
3
12
5