Ottobock 1S101 SACH+ Instructions D'utilisation page 10

The product is recommended for mobility grade 1 (indoor
walker) and mobility grade 2 (restricted outdoor walker).
m°
kg
• The maximum approved body weight is specified in the technical
data (see page 14).
2.3 Environmental conditions
Storage and transport
Temperature range –20 °C to +60 °C (–4 °F to +140 °F), relative
humidity 20 % to 90 %, no mechanical vibrations or impacts
Allowable environmental conditions
Temperature range: –10 °C to +45 °C (14 °F to 113 °F)
Chemicals/liquids: fresh water, soapsuds, chlorine water
Moisture: Submersion: max. 1 h in 2 m depth, relative humidity: no
restrictions
Solids: Dust, occasional contact with sand
Clean the product after contact with humidity/chemic­
als/solids, in order to avoid increased wear and damage (see
page 13).
Prohibited environmental conditions
Solids: highly hygroscopic particles (e.g. talcum), dust in high con­
centrations (e.g. construction site), intensive contact with sand
Chemicals/liquids: salt water, perspiration, urine, acids, continu­
ous use in liquid media
2.4 Lifetime
The product was tested by the manufacturer with 2 million load
cycles. Depending on the user's activity level, this corresponds to a
maximum lifetime of 3 years.
10
3 Safety
3.1 Explanation of warning symbols
Warning regarding possible risks of accident or
CAUTION
injury.
Warning regarding possible technical damage.
NOTICE
3.2 General safety instructions
CAUTION!
Risk of injury and risk of product damage
► To avoid the risk of injury and product damage, do not use the
product beyond the tested lifetime.
► To avoid the risk of injury and product damage, only use the
product for a single patient.
► Comply with the product's field of application and do not expose
it to excessive strain (see page 9).
► Note the combination possibilities/combination exclusions in the
instructions for use of the products.
NOTICE!
Risk of product damage and limited functionality
► Do not expose the product to prohibited environmental condi­
tions.
► Check the product for damage if it has been exposed to prohib­
ited environmental conditions.
► Do not use the product if it is damaged or in a questionable con­
dition. Take suitable measures (e.g. cleaning, repair, replace­
ment, inspection by the manufacturer or a specialist workshop).
► Clean the product promptly after contact with salt water, water
containing chlorine/soap or abrasive substances (e.g. sand).