−
press the (+) button; the display shows "OF" and the "...key..." symbol.
At this point the safety lock is activated and after about 5 seconds the display
shows the current time and the "...key..." symbol.
Deactivating the lock:
−
press the (-) and (+) buttons at the same time for about 8 seconds
−
the display shows "OF"; release the buttons
−
press the (+) button; the display shows "ON"
At this point the safety lock is deactivated and after about 5 seconds the display
shows the current time.
Electronic touch programmer
Setting the current time
When the power is connected, "12:00" and the
symbol
flash on the display. By touching
any one of the controls (+, - or SELECT), the
symbol MAN appears and it is possible to set
the time, pressing the - or + buttons within 5
seconds.
Subsequent adjustments of the time can be
made by repeatedly touching the SELECT
control until the
adjusting the time as described above.
General notes
− Setting the current time whilst an automatic programme is active will cancel the
programme.
− The loudness of the buzzer can be modified by repeatedly touching the
SELECT control until the level set appears (L1, L2 or L3) and pressing + or -.
− If not deactivated, the buzzer stops automatically after about 7 minutes.
− The maximum programming time is 23 hours 59 minutes.
− If there is a power cut, all the programmed settings are cancelled; when power
returns, the display flashes, showing 12:00. To restore the functioning of the
appliance, reset the current time and any programme.
Timer buzzer
To use it as a simple timer, touch the SELECT control repeatedly until the
symbol flashes, set the time desired, pressing + or -, after about 5 seconds the
symbol stops flashing and the time starts to decrease; to modify the time set or
zero it, press + or -.
When the time is finished, touch any one of the controls to deactivate the buzzer.
The maximum time that can be set is 99 minutes.
INSTRUCTIONS FOR USE
symbol flashes and
9 - GB
SELECT