Aventics DDL Mode D'emploi page 79

AVENTICS | DDL | R412009417–BDL–001–AD
Uncontrolled actuator movements when the pneumatics are
switched on
Danger of injury if the system is in an undefined state or the
manual overrides are set to position "1".
Put the system in a defined state before switching it on.
O
Set all manual overrides to position "0".
O
Make sure that no personnel are within the hazardous
O
zone when the pressure is switched on.
Also observe the applicable instructions and safety
O
information in the VS operating instructions.
1. Switch on the operating voltage.
2. Check the LED displays on the module.
3. Switch on the compressed air supply.
Commissioning and Operation
CAUTION
79