Output Data Section In The Controller - Aventics DDL Mode D'emploi

Table 11: Assignment of the output bits for double-solenoid valves
1)
Byte Applies to
X Valve
Solenoid
X+1 Valve
Solenoid
X+2 Valve
Solenoid
X+3 Valve
Solenoid
1)
Byte X is the start address for the output section of this module in the controller.
AVENTICS | DDL | R412009417–BDL–001–AD
Table 10: Selecting the output data length on the S6 switch,
bits 3 and 4
Data length Valve solenoids
1 byte 8
2 bytes 16
3 byte 24
4 bytes (default) 32
Changes are only taken over after a voltage reset. When
making changes, turn the DDL line supply voltage off and
then on again.
Further information on the addressing rules can be found in
the "DDL Drive & Diagnostic Link" system description
R499050030 (German), R499050031 (English).
7.1.4

Output data section in the controller

The DDL address determines the position of the output data in
the data range of the bus coupler, and thus the position in the
address range in the controller.
If the address 0 (automatic addressing) is set, the VS will act like
a valve unit.
The valve system occupies 1 to 4 bytes in the output section of
the controller, depending on the set length.
The following tables show the assignment of the output bits to
the valves and solenoids.
Bit 7 Bit 6 Bit 5
4 4 3
12 14 12
8 8 7
12 14 12
12 12 11
12 14 12
16 16 15
12 14 12
Commissioning and Operation
Bit 3
Off
On
Off
On
Bit 4 Bit 3 Bit 2
3 2 2
14 12 14
7 6 6
14 12 14
11 10 10
14 12 14
15 14 14
14 12 14
67
Bit 4
Off
Off
On
On
Bit 1 Bit 0
1 1
12 14
5 5
12 14
9 9
12 14
13 13
12 14