Setting The Demo Mode - Yamaha YSP-4000 Mode D'emploi

Adjusting the system parameters
5
Press / to switch between "MON CHK:
YES" and "MON CHK: SKIP".
• Select MON CHK: YES to activate the monitor
check function.
• Select MON CHK: SKIP to deactivate the monitor
check function.
6
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
The new setting will be activated when you turn on
the power of this unit next time.
Note
If you change the setting of "MONITOR CHECK", "UP-
SCALING" is automatically set to "OFF" (see page 87).
98
En
ENTER

Setting the DEMO MODE

You can test the sound beam output from this unit to
experience the sound beam.
1
Repeat steps 1 to 3 in "Using the system
parameters" on page 94.
2
Set the operation mode selector to YSP.
TV/AV
YSP
3
Press / so that "DEMO MODE" is
displayed in the front panel display.
4
Press ENTER.
ENTER
ENTER