Setting The Auto Power Standby Function; Initializing The Sound Bar - Yamaha ATS-1050 Mode D'emploi

Setting the auto power standby function

By enabling the auto power standby function, you can avoid forgetting to turn off the
sound bar after use, or if you fall asleep while watching TV.
NOTE
• When the auto power standby function is enabled and one of the following conditions is met, the sound bar
will automatically turn off.
− No operations for 8 hours
− No audio input and no operations for 20 minutes when BLUETOOTH is selected as the input source.
1
With the sound bar turned off, hold down the MUTE key on the sound
bar's remote control for more than 3 seconds to enable/disable the
auto power standby function.
You can check the status of the auto power standby function with the indicators on
the top panel for several seconds right after the sound bar is turned on.
Off (enabled), lights up (disabled)
HINT
• Initial setting varies depending on the country or region.
− U.K. and Europe models: enabled
− Other models: disabled

Initializing the sound bar

Follow the procedure below to initialize the sound bar.
1
Turn off the sound bar.
2
Hold down (power) on the rear panel of the sound bar for more
than 3 seconds.
Flash (initialized)
15