Publicité
Les langues disponibles
Les langues disponibles
The installer must carry out a risk analysis and check that the system does not feature crushing or shearing points. If necessary, corrective
measures must be implemented and signals required by current regulations must be applied in order to make the dangerous areas visible.
The identification data of the motorised system must be clearly visible on each installation.
The installer must provide full information about the automatic, manual and emergency functioning of the equipment and deliver the
operating instructions to the system user. Only use original spare parts for any repairs or for replacing parts.
The guarantee is void if this product is used in combination with others of other brands.
The manufacturer of the drive declines any responsibility if components incompatible with safety and correct operation are installed.
Warning
• The whole system must be built in full compliance with standards CEI 61 - 1 and CEI 64 - 8
• The installer must check that the temperature range indicated on the label is compatible with the place of installation.
• The accessories shown in the figure are not supplied with the equipment.
• For connections use an electrical cable with a cross-section of 1.5 sq.mm FROR CEI 20-22.
• To fix the plastic box of the equipment use the pre-cut holes in the box, fix with plugs suitable for the support you have chosen
and seal with silicone.
• If a protection sheath is required on the actuator power cable, carry out this operation before
connecting the cable to the junction boxes.
• If the power cable is damaged, it must be replaced by qualified service personnel.
Control equipment ...................................................
Actuator ...................................................................
Antenna 433.92 MHz ...............................................
Flashing light ...........................................................
Pair of photocells .....................................................
Key-operated switch ................................................
OPTIONAL control devices.....................................
Proximity reader*, Card reader* ..............................
remote control
LBT0499 – DS41627-001 – FW 1.01 - 2020
System type
2 x 1.5 sq.mm + ground
3 x 1.5 sq.mm + ground
Supplied cable
2 x 1 sq.mm
Emitter 2 x 0.75 sq.mm: receiver 4 x 0.75 sq.mm
3 x 0.75 sq.mm
3 x 0.75 sq.mm
Gate keypad*
*optional accessory (refer to the sale catalogue)
Fig.7
Publicité
